This machine is designed to cut spiral ductwork up to 0.9 mm thick in diameters from 80 to 315 mm and lengths up to 3 m. Precise and clean cuts are delivered every time.
The SR Cutter is portable and can be set up in just a few minutes.
To make a cut, the operator ensures that the length of duct is held firmly in place by the telescopic arm. The ‘knife’ is then used to pierce the duct close to a spiral fold to create a starting point for the automatic shears.
There are also mounting points for the special pliers kit required for the new Lindab Lindab m system.
For more information on this story, click here:Dec 2007, 101
Related articles:
